[Previous][Next]
DIAGNOSTIC TROUBLE CODE CHART
caution
  • During diagnosis, a diagnostic trouble code (DTC) associated with other system may be set when the ignition switch is turned to the "ON" position with connector(s) disconnected. On completion, confirm all systems for DTC(s). If DTC(s) are set, erase them all.
noteFor electric power steering system the power supply may not shut off immediately after the ignition switch is turned to the "LOCK" (OFF) position.
DTC No.Scan tool (M.U.T.-III) displayReference pages
C1511Torque sensor main
C1512Torque sensor sub
C1513Torque sensor main/sub voltage
C1514Torque sensor power supply
C1516Torque sensor power voltage low
C1531Motor terminal voltage
C1532Motor current too large
C1533Motor over current
C1534Motor current too small
C1550ECU failure
C1560Vehicle speed data (CAN)
C1564Vehicle speed data invalid
C1565Engine revolution data invalid
C1657Implausible coding data
C1860Power supply high voltage
C1861Power supply low voltage
U0100Engine CAN timeout
U0126SAS CAN timeout
U0141ETACS CAN timeout
U0428SAS (CAN message)
U1073Bus-off
U1108Meter CAN timeout/Not equipped
U1190No receive fault detect signal
U1195Coding not completed
U1197Coding data unavailable
U1200SAS parity error
U1204SAS message counter error