37-U1195 VARIANT CODING NOT COMPLETED

DTC U1195: Coding not completed
DTC U1197: Coding data unavailable

caution

If there is any problem in the CAN bus lines, an incorrect diagnostic trouble code (DTC) may be set. Prior to this diagnosis, diagnose the CAN bus lines (Refer to GROUP 54C - CAN Bus Diagnostics Table ).
Whenever ECU is replaced, ensure that the CAN bus lines are normal.

OPERATION

EPS-ECU receives variant coding data from the ETACS-ECU.

DIAGNOSTIC TROUBLE CODE SET CONDITIONS

The EPS-ECU coding is not completed.
The coding data is not sent from the ETACS-ECU, and the microcomputer determines that there is a problem in the system.

PROBABLE CAUSES

DIAGNOSIS

STEP 1. Using scan tool (M.U.T.-III), diagnose the CAN bus lines.

Use scan tool (M.U.T.-III) to diagnose the CAN bus lines.

Is the check result normal?

Go to Step 2

Repair the CAN bus lines (Refer to GROUP 54C - CAN Bus Diagnostics Table

). On completion, go to Step 2

STEP 2. Use scan tool (M.U.T.-III) to confirm a diagnostic trouble code of other systems.

Check if the ETACS-ECU set a diagnostic trouble code.

Is the diagnostic trouble code set?

Diagnose the ETACS-ECU (Refer to GROUP 54A - Diagnosis, Diagnostic Trouble Code Chart

Go to Step 3

STEP 3. Check whether the diagnostic trouble code is set again.

(1) Erase the diagnostic trouble code.

(2) Turn the ignition switch from the "LOCK" (OFF) position to the "ON" position.

(3) Check if the diagnostic trouble code is set.

Is DTC U1195 or U1197 set?

Replace the EPS-ECU (Refer to

). Then go to Step 4

Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points, How to Cope with Intermittent Malfunction

STEP 4. Check whether the diagnostic trouble code is set again.

(1) Erase the diagnostic trouble code.

(2) Turn the ignition switch from the "LOCK" (OFF) position to the "ON" position.

(3) Check if the diagnostic trouble code is set.

Is DTC U1195 or U1197 set?

Return to Step 1

This diagnosis is complete.