[Previous][Next]
Removal and Installation
 
 
<RH>
Pre-removal and Post-installation Operation
Removal steps
1.Tool lid mask A
2.Tool lid mask B
3.Parcel strap hook
4.Seatback release lever cap
5.Luggage side lower finisher assembly
6.Accessory socket <Vehicles with accessory socket>
7.120V AC socket <Vehicles with 120V AC socket>
8.120V AC socket bezel <Vehicles with 120V AC socket>
9.120V AC socket bracket <Vehicles with 120V AC socket>
10.Luggage side finisher lid A
11.Luggage side finisher lid B
12.Luggage side finisher pocket
13.Luggage side finisher hook
14.Seatback release lever
15.Seatback release cable
16.Rear seat belt clip
17.Washer
18.Luggage side lower finisher
Cargo floor box (Refer to Removal and Installation)
19.Luggage side finisher bracket lower
Cargo floor pad (Refer to Removal and Installation)
20.Rear wheelhouse silencer
21.Luggage side upper finisher cap
Rear seat belt pre-tensioner (Refer to Seat Belt Pre-tensioner Removal and Installation)
Third seat belt (Refer to Third Seat Belt Removal and Installation)
22.Luggage side upper finisher
Required Special Tool:
  • MB990784: Ornament Remover
 
 
<LH>
Pre-removal and Post-installation Operation
Removal steps
1.Tool lid mask
2.Parcel strap hook
3.Seatback release lever cap
4.Luggage room lamp assembly
5.Luggage side lower finisher assembly
6.Luggage side finisher lid
7.Luggage side finisher pocket
8.Luggage side finisher hook
9.Seatback release lever
10.Seatback release cable
11.Rear seat belt clip
12.Washer
13.Luggage side lower finisher
Cargo floor box (Refer to Removal and Installation)
14.Luggage side finisher bracket lower
Cargo floor pad (Refer to Removal and Installation)
15.Rear wheelhouse silencer
16.Luggage side upper finisher cap
Rear seat belt pre-tensioner (Refer to Seat Belt Pre-tensioner Removal and Installation)
Third seat belt (Refer to Third Seat Belt Removal and Installation)
17.Luggage side upper finisher
Required Special Tool:
  • MB990784: Ornament Remover
 
 
REMOVAL SERVICE POINTS
 
 
<<A>> TOOL LID MASK B/TOOL LID MASK REMOVAL
Remove the claws shown in the figure using special tool MB990784.
 
 
 
<<B>> LUGGAGE SIDE LOWER FINISHER ASSEMBLY REMOVAL
1. Disengage the seatback release cable assembly and the luggage side lower finisher assembly.
2. Remove the clips and release the claws shown in the figure using special tool MB990784.
3. Leave the seatback release cable assembly on the second seat assembly side and remove the luggage side lower finisher assembly.
 
 
 
<<C>> LUGGAGE SIDE UPPER FINISHER REMOVAL
Remove the clips shown in the figure using special tool MB990784.