[Previous][Next]
REMOVAL AND INSTALLATION
 
 
Pre-removal operation
Post-installation operation
Back door assembly removal steps
1.Back door opening weatherstrip
•Back door inner finisher (Refer to Back Door Trim Removal and Installation)
2.Back door wiring harness connector connection
3.Back door gas spring connection
4.Back door panel
•Headlining (Refer to Headlining Removal and Installation)
5.Back door hinge
6.Back door weatherstrip
7.Back door damper upper
8.Shim <Vehicles with shim>
•Rear bumper assembly (Refer to Rear Bumper Assembly Removal and Installation)
9.Back door damper lower
10.Damper
 
 
REMOVAL SERVICE POINT
 
 
<<A>> BACK DOOR GAS SPRING CONNECTION REMOVAL
caution
  • Do not disassemble or throw the back door gas spring assembly into the fire.
  • Before disposal, make a hole to remove the gas.
  • Make sure that the piston rod should not collect any foreign particles.
  • When disconnecting the back door gas spring, support the back door assembly to prevent it from falling.
Slide the pin and remove the back door gas spring assembly from the ball joint in the direction of the arrow.
 
 
 
 
INSTALLATION SERVICE POINTS
 
 
>>A<< BACK DOOR HINGE INSTALLATION
Apply the specified sealant to the back door hinge mounting surface, and install the back door hinge.
Specified Adhesive: 3M™ AAD Part No.8531 Heavy drip check sealer, 3M™ AAD Part No.8646 Automotive joint and seam sealer or equivalent
 

 
 
>>B<< BACK DOOR OPENING WEATHERSTRIP INSTALLATION
The marking on the back door opening weatherstrip should be positioned at the center of the body.