[Previous][Next]
BACK DOOR ADJUSTMENT
cautionWhen you have adjusted the striker so that it is engaged with the latch properly and adjusted the back door height, you should check the camera image on the multi around monitor "Bird-eye view." If necessary, calibrate the monitor. <Vehicles with multi around monitor>
 
 
ADJUSTMENT OF ENGAGEMENT BETWEEN STRIKER AND LATCH
1. Remove the Luggage Rear Plate (Refer to Luggage Trim Removal and Installation).
2. Replace the striker mounting screws with temporary bolts, and use the remover bar (special tool: MB990939) and a hammer to tap the temporary bolt to the desired direction.
3. Tighten the striker mounting screws.
Tightening torque:
21 ± 4 N·m (15 ± 2 ft-lb)
4. Install the Luggage Rear Plate (Refer to Luggage Trim Removal and Installation).
 
 
 
ADJUSTMENT OF CLEARANCE BETWEEN BACK DOOR AND BODY
1. Loosen the back door mounting bolts to adjust the clearance between the back door and body.
2. Tighten the back door hinge mounting bolts.
Tightening torque:
24 ± 4 N·m (18 ± 2 ft-lb)