[Previous][Next]
Removal and Installation
 
 
<FLOOR TRIM>
Removal steps
1.Front kicking plate
Hood lock release handle (Refer to HOOD LATCH AND CABLE REMOVAL AND INSTALLATION).
2.Dash side finisher
3.Rear kicking plate
 
 
<PILLAR TRIM>
Removal steps
Door opening inner weatherstrip (Refer to WINDOW GLASS RUNCHANNEL AND DOOR OPENING WEATHERSTRIP REMOVAL AND INSTALLATION).
1.Front pillar garnish
2.Front pillar garnish clip
3.Seat belt cover
4.Center pillar lower garnish
5.Center pillar upper garnish
 
 
REMOVAL SERVICE POINT
 
 
<<A>> FRONT PILLAR GARNISH REMOVAL
Cut the front pillar garnish clip at the cutting position shown in the figure, and remove the front pillar garnish.
 
 
 
 
INSTALLATION SERVICE POINT
 
 
>>A<< FRONT PILLAR GARNISH CLIP INSTALLATION
Install the clip as shown in the figure while making sure that its hatched part does not protrude from the position of the clip base.
 
 
 
 
<CARGO ROOM TRIM>
Removal steps
1.Tonneau cover assembly
Tool lid mask B (Refer to Removal and Installation)
2.Cargo floor box lid A
3.Luggage rear plate mask
4.Luggage rear plate
5.Cargo floor box lid B
6.Cargo floor lid bracket
Tool lid mask (Refer to Removal and Installation)
7.Cargo floor cover
Luggage side lower finisher assembly (Refer to Removal and Installation)
8.Cargo floor carpet
9.Cargo floor box
Luggage side finisher bracket lower (Refer to Removal and Installation)
10.Cargo floor pad
Required Special Tool:
  • MB990784: Ornament Remover
 
 
REMOVAL SERVICE POINT
 
 
<<A>> LUGGAGE REAR PLATE REMOVAL
Remove the clips shown in the figure using special tool MB990784.