[Previous][Next]
REMOVAL AND INSTALLATION
 
 
Pre-removal operation
Post-installation operation
Back door assembly removal steps
1.Back door opening weatherstrip
Back door inner finisher (Refer to Back Door Trim Removal and Installation).
2.Back door wiring harness connector connection
3.Spindle unit
4.Back door panel
Headlining (Refer to Headlining Removal and Installation).
5.Back door hinge
6.Back door upper weatherstrip
7.Back door damper upper
8.Shim <Vehicles with shim>
9.Back door damper lower
10.Damper
 
 
INSTALLATION SERVICE POINTS
 
 
>>A<< BACK DOOR HINGE INSTALLATION
Apply the specified sealant to the back door hinge mounting surface, and install the back door hinge.
Specified Adhesive: 3M™ AAD Part No.8531 Heavy drip check sealer, 3M™ AAD Part No.8646 Automotive joint and seam sealer or equivalent
 

 
 
>>B<< BACK DOOR OPENING WEATHERSTRIP INSTALLATION
The marking on the back door opening weatherstrip should be positioned at the center of the body.