[Previous][Next]
Removal and Installation
warning
  • Before servicing, electric motor switch OFF, disconnect 12V battery negative terminal and wait for 3 minutes or more (discharges electricity held in the additional power supply circuit of the air bag diagnosis sensor unit).
  • Battery posts, terminals and related accessories contain lead and lead compounds. WASH HANDS AFTER HANDLING.
  • Never place seat belt pre-tensioner retractor and lap pre-tensioner in an area where the temperature reaches 80°C (176°F) or more.
 
 
Pre-removal Operation
Change the power supply mode of the electric motor switch to OFF.
 
 
<FRONT>
Seat belt pre-tensioner removal steps
Disconnect the 12V battery negative (–) terminal.
Center pillar lower garnish (Refer to Interior Trim Removal and Installation)
1.Adjuster cover
2.Seat belt pre-tensioner
3.Center pillar upper garnish (Refer to Interior Trim Removal and Installation)
4.Seat belt adjuster
Seat belt pre-tensioner installation steps
4.Seat belt adjuster
3.Center pillar lower garnish (Refer to Interior Trim Removal and Installation)
2.Seat belt pre-tensioner
1.Adjuster cover
Center pillar lower garnish (Refer to Interior Trim Removal and Installation)
Connect the 12V battery negative (–) terminal.
 
 
<REAR>
Rear seat belt pre-tensioner removal steps
Disconnect the 12V battery negative (–) terminal.
Luggage side upper finisher (Refer to Luggage Trim Removal and Installation)
1.Rear seat belt pre-tensioner
Rear seat belt pre-tensioner installation steps
1.Rear seat belt pre-tensioner
Luggage side upper finisher (Refer to Luggage Trim Removal and Installation)
Connect the 12V battery negative (–) terminal.
 
 
REMOVAL SERVICE POINTS
 
 
<<A>> SEAT BELT PRE-TENSIONER REMOVAL
1. Use the flat-tipped screwdriver to pull out the locking button of wiring harness side connector, and release the lock.
 
 
 
 
INSTALLATION SERVICE POINT
 
 
>>A<< SEAT BELT PRE-TENSIONER INSTALLATION
Insert the claws of the seat belt retractor into the body, and install the seat belt retractor in order of the numbers shown in the figure.