Removal and Installation

caution

Before removal of the driver/passenger air bag module and driver knee air bag module, always observe the service procedures described in Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"

, passenger air bag moduleRemoval and Installation

, and driver knee air bag moduleRemoval and Installation

Pre-removal and post-installation operation

Recycle Refrigerant/Charge (Refer to Recycle Refrigerant/Charge Refrigerant)
Engine coolant replacement (Refer to ENGINE COOLANT REPLACEMENT)
Instrument panel assembly Removal and Installation(Refer to Instrument panel assembly Removal and Installation)
Ventilator duct Removal and Installation(Refer to Removal and Installation)
Front wiper drive assembly Removal and Installation(Refer to Front wiperRemoval and Installation)
8CH CAN gateway Removal and Installation(Refer to 8CH CAN gatewayRemoval and Installation)

			Removal steps
		1.	Heater hose connection
		•	Center ventilator duct and Rear heater duct removal steps (Refer to Removal and Installation)
		•	Around view monitor control unit(Refer to Around view monitor control unit REMOVAL AND INSTALLATION)
		•	Disconnect air bag diagnosis sensor unit (Refer to Air bag diagnosis sensor unit Removal and Installation)
		•	Center console (Refer to Floor console assemblyRemoval and Installation)
		•	ADAS C/U (Refer to ADAS C/U 2Removal and Installation)
		•	Electrical parking driver unit (Refer to Electrical parking driver unitREMOVAL AND INSTALLATION)
		•	Cowl top (Refer to Cowl topRemoval and Installation)
		2.	A/C pipe assembly connection
		3.	O-ring
		4.	Steering member
		5.	A/C Evaporator drain hose
		6.	Heater & cooling unit assembly

REMOVAL SERVICE POINT

<<A>> A/C PIPE ASSEMBLY DISCONNECTION

caution

As the compressor oil and receiver are highly moisture absorbent, use a non-porous material to plug the hose and nipples.

To prevent the entry of dust or other foreign bodies, plug the dismantled hose and the nipples of the expansion valves.