[Previous][Next]
REMOVAL AND INSTALLATION
 
 
Pre-removal Operation
  • Radiator Grill Removal (Refer to ).
  • Front Wheelhouse Splash Shield Mounting Clips Removal (Refer to GROUP 42A, Splash Shield ).
  • Engine Room Under Cover Front A, B Removal (Refer to ).
  • Front Wiring Harness and Front Turn-signal Light Wiring Harness Connector Disconnection <Vehicles without Front Fog Light>
  • Front Wiring Harness and Front Turn-signal Light and Front Fog Light Wiring Harness Connector Disconnection <Vehicles with Front Fog Light>
Post-installation Operation
  • Front Wiring Harness and Front Turn-signal Light Wiring Harness Connector Connection <Vehicles without Front Fog Light>
  • Front Wiring Harness and Front Turn-signal Light and Front Fog Light Wiring Harness Connector Connection <Vehicles with Front Fog Light>
  • Engine Room Under Cover Front A, B Installation (Refer to ).
  • Front Wheelhouse Splash Shield Mounting Clips Installation (Refer to GROUP 42A, Splash Shield ).
  • Radiator Grill Installation (Refer to ).
  • Front Fog Light Aiming Adjustment <Vehicles with Front Fog Light> (Refer to GROUP 54A, Turn-signal Light and Fog Light - On-vehicle Service ).
Removal steps
<<A>>1.Front bumper assembly
2.Front bumper cover LH
3.Front bumper cover RH
4.Front bumper core LH <Apply to production vehicle up to late February, 2021>
5.Front bumper core RH <Apply to production vehicle up to late February, 2021>
Hood latch (Refer to GROUP 42A - Hood .)
Hood lock release cable (Refer to GROUP 42A - Hood .)
Radiator cap assembly bracket and radiator upper hose (Refer to GROUP 14 - Radiator .)
Air cleaner intake duct (Refer to GROUP 15 - Air cleaner .)
Horn (HI) and horn (LO) (Refer to GROUP 54A - Horn .)
Front impact sensor (Refer to GROUP 52B - Front Impact Sensor .)
6.Headlight support upper panel (Refer to GROUP 42A - Loose Panel .)
Ambient temperature sensor (Refer to GROUP 55A - Ambient Temperature Sensor .)
>>A<<7.Front bumper reinforcement A
8.Front fender bracket
 
 
REMOVAL SERVICE POINT
 
 
<<A>> FRONT BUMPER ASSEMBLY REMOVAL
cautionTo prevent the front wheel arch molding from damage, pull it gradually and do not over-pull it.
Before removing the front bumper assembly, release the front part of the front wheel arch molding by pulling and unclipping it outwards. This makes the bumper removal possible without removing the entire front wheel arch molding.
 
 
 
 
INSTALLATION SERVICE POINT
 
 
>>A<< FRONT BUMPER REINFORCEMENT A INSTALLATION
Tighten the front bumper reinforcement A bolts in the numerical order to 20 ± 5 N·m (15 ± 3 ft-lb).