[Previous][Next]
REMOVAL AND INSTALLATION
warning
  • Never repair or disassemble the front impact sensor. If faulty, replace it.
  • Handle the front impact sensors very carefully, taking care not to drop them. They must be replaced if they are dropped.
  • Replace the sensors with new ones after the air bag has deployed.
 
 
Pre-removal Operation
  • Turn the ignition key to the "LOCK" (OFF) position.
Front impact sensor <LH>
Removal steps
<<A>>1.Negative (-) battery cable
Headlight support upper panel cover (Refer to Group 51, Front bumper )
Air cleaner intake duct (Refer to Group 15, Air cleaner )
<<B>>2.Front impact sensor connector connection
3.Front impact sensor
Installation steps
>>A<<Pre-installation inspection
>>B<<3.Front impact sensor
2.Front impact sensor connector connection
Air cleaner intake duct (Refer to Group 15, Air cleaner )
Headlight support upper panel cover (Refer to Group 51, Front bumper )
>>C<<Post-installation inspection

Front impact sensor <RH>
Removal steps
<<A>>1.Negative (-) battery cable
Headlight support upper panel cover (Refer to Group 51, Front bumper )
<<B>>2.Front impact sensor connector connection
3.Front impact sensor
Installation steps
>>A<<Pre-installation inspection
>>B<<2.Front impact sensor
1.Front impact sensor connector connection
Headlight support upper panel cover (Refer to Group 51, Front bumper )
>>C<<Post-installation inspection
 
 
REMOVAL SERVICE POINTS
 
 
<<A>> NEGATIVE (-) BATTERY CABLE DISCONNECTION
dangerWait at least 60 seconds after disconnecting the battery cable before doing any further work (Refer to ).
warningBattery posts, terminals and related accessories contain lead and lead compounds. WASH HANDS AFTER HANDLING.
Disconnect the negative (-) battery cable from the battery and tape the terminal to prevent accidental connection and air bag(s) deployment.
 

 
 
<<B>> FRONT IMPACT SENSOR CONNECTOR DISCONNECTION
Push the connector lock of front impact sensor connector to the direction of the arrow, then unlock and disconnect the connector.
 
 
 
 
INSTALLATION SERVICE POINTS
 
 
>>A<< PRE-INSTALLATION INSPECTION
Check the front impact sensor before installation (Refer to ).
 
 
 
>>B<< FRONT IMPACT SENSOR INSTALLATION
warningThe SRS may not activate properly if a front impact sensor is not installed properly, which could result in serious injury or death to the vehicle's driver.
1. Securely connect the connector.
2. Position the front impact sensor facing toward the front of the vehicle as indicated by the arrow on the label, and install it securely.
 
 
 
>>C<< POST-INSTALLATION INSPECTION
1. Reconnect the negative (-) battery cable.
2. Turn the ignition key to "ON" position.
3. Does the "SRS" warning light illuminate for approximately seven seconds, and then go out?
4. If yes, the SRS system is functioning properly.
If not, consult page .