[Previous][Next]
REMOVAL AND INSTALLATION
 
 
caution
  • Disconnect the battery (-) terminal and wait for 60 seconds or more before starting work. Insulate the disconnected (-) terminal by wrapping a tape.
  • Handle the front impact sensor with sufficient caution, and do not drop the sensor or allow contact with water, oil, or others. If a dent, crack, deformation and others are discovered, replace it with a new one.
Headlight support upper panel removal steps
Front bumper assembly removal and installation (Refer to GROUP 51 - Front Bumper Assembly )
1.Front bumper cover LH
2.Front bumper cover RH
Hood latch switch harness and front harness connection
3.Hood lock release cable
4.Hood latch
5.Radiator cap assembly bracket and radiator upper hose <4B1>
6.Air cleaner intake duct
Horn (HI), horn (LO) (Refer to GROUP 54A - Horn )
Front impact sensor (Refer to GROUP 52B - Front impact sensor )
>>A<<7.Headlight support upper panel
Dash panel heat protector removal
8.Dash panel heat protector
Rear seat crossmember removal
9.Rear seat crossmember
Tie down hook rear removal
10.Tie down hook rear
Rear end brace removal
11.Rear end brace
Rear wheelhouse brace removal
12.Rear wheelhouse brace
 
 
INSTALLATION SERVICE POINT
 
 
>>A<< HEADLIGHT SUPPORT UPPER PANEL INSTALLATION
Tighten the headlight support upper panel mounting bolts in the numerical order to 11 ± 3 N·m (97 ± 26 in-lb).