[Previous][Next]
DIAGNOSTIC TROUBLE CODE CHART
caution
  • During troubleshooting, a DTC associated with other system may be set when the ignition switch is turned on with connector(s) disconnected. On completion, confirm all systems for DTCs. If DTCs are set, erase them all.
  • When you replace the camera-ECU, you should teach the camera-ECU for the multi-around monitor by writing a learned value. On completion, you should check the camera image on the multi around monitor "Bird's eye-view." If necessary, calibrate the camera.
  • When you remove/install or replace the camera, you should check the camera image on the multi around monitor "Bird's eye-view." If necessary, calibrate the camera.
DTC No.Diagnostic itemReference page
B2501Rear view camera fault
B2503Nose view camera fault
B2505ECU internal error (EEPROM) fault
B2540CPU fault
B2541ASIC fault
B2542SDRAM fault
B2543EEPROM fault at start up
B2544Flash ROM fault
B2546LH side view CAMERA fault
B2547RH side view CAMERA fault
B2548Calibration not completed
B254ASteering angle sensor fault
B254BCAMERA output voltage fault
B254ECamera ECU output pictures fault
B254FIG status fault
U0100Engine CAN timeout
U0141ETACS CAN timeout
U0155Meter CAN timeout
U0245NAVI/DISP.AUDIO CAN timeout
U1195Coding not completed
U1197Coding data unavailable