[Previous][Next]
DTC B2548: Calibration not completed
 
 
 
 
TROUBLE JUDGMENT
When the camera-ECU has not been calibrated, DTC No. B2548 will be set.
note
  • "!" mark is displayed against the camera, which has not been calibrated yet, when DTC No. B2548 is set.
  • DTC No. B2548 will be erased automatically after learned values are written to the camera-ECU successfully or a relevant camera has been calibrated.
 
 
TROUBLESHOOTING HINTS
  • The camera-ECU not calibrated
  • The camera-ECU may be defective
 
 
DIAGNOSIS
Recheck for diagnostic trouble code.
Calibrate the camera-ECU, and check again if the DTC is set in the camera-ECU.
(1) Calibrate the camera-ECU (Refer to ).
(2) Turn the ignition switch from the "LOCK" (OFF) position to the "ON" position.
(3) Check if DTC is set.
Is the DTC set?
Repeat the calibration (Refer to ).
The procedure is complete.