[Previous][Next]
DTC C1565 Engine revolution data invalid
 
 
caution
  • If there is any problem in the CAN bus lines, an incorrect DTC may be set. Prior to this diagnosis, diagnose the CAN bus lines (Refer to GROUP 54C, CAN Bus Diagnostics Table ).
  • Whenever ECU is replaced, ensure that the CAN bus lines are normal.
 
 
OPERATION
  • EPS-ECU receives engine revolution signal from the ECM.
 
 
 
FUNCTION
The engine speed signal is sent to the EPS-ECU for motor control.
 
 
 
TROUBLE JUDGMENT
Check Conditions
  • The power supply circuit system DTC (No. C1540, C1541) is not set.
  • The engine circuit system DTC is not set.
Judgment Criterion
  • If the microcomputer receives abnormal engine speed signal from the ECM, it determines that the engine speed calculation system is defective.
Fail Safe, Back Up Function
  • The EPS-ECU displays the electric power steering warning symbol, and sets DTC No. C1565 to limit the power assistance.
 
 
 
TROUBLESHOOTING HINTS
  • Malfunction of CAN bus line
  • Malfunction of the EPS-ECU
  • Malfunction of the ECM
 
 
 
 
DIAGNOSIS
STEP 1. Scan tool (M.U.T.-III) CAN bus diagnostics
(1)
cautionTo prevent damage to scan tool (M.U.T.-III), always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool (M.U.T.-III).
Connect scan tool (M.U.T.-III). Refer to "How to connect the Scan Tool (M.U.T.-III) ."
(2) Turn the ignition switch to the "ON" position.
(3) Diagnose the CAN bus line.
(4) Turn the ignition switch to the "LOCK" (OFF) position.
Is the check result normal?
Go to Step 3.
Repair the CAN bus lines (Refer to GROUP 54C - CAN Bus Diagnostics Table ). On completion, go to Step 2.
 
STEP 2. DTC recheck after resetting CAN bus lines
(1) Erase the DTC.
(2) Turn the ignition switch from the "LOCK" (OFF) position to the "ON" position.
(3) Check if the DTC is set.
Is DTC C1565 set?
Go to Step 3.
This diagnosis is complete.
 
STEP 3. Scan tool (M.U.T.-III) data list
Check the following service data (Refer to ).
  • Item No. 07: Engine speed
Is the check result normal?
Go to Step 5.
Perform troubleshooting for ECM (Refer to GROUP 13A - Troubleshooting/Inspection Chart for DTC <2.4L Engine> or GROUP 13B - Troubleshooting/Inspection Chart for DTC <3.0L Engine>). Then go to Step 4.
 
STEP 4. Check whether the DTC is set again.
(1) Erase the DTC.
(2) Turn the ignition switch from the "LOCK" (OFF) position to the "ON" position.
(3) Check if the DTC is set.
Is DTC C1565 set?
Replace the EPS-ECU (Refer to ). Then go to Step 5.
Intermittent malfunction (Refer to GROUP 00 - How to Cope with Intermittent Malfunction ).
 
STEP 5. Check whether the DTC is set again.
(1) Erase the DTC.
(2) Turn the ignition switch from the "LOCK" (OFF) position to the "ON" position.
(3) Check if the DTC is set.
Is DTC C1565 set?
Return to Step 1.
This diagnosis is complete.