[Previous][Next]
REMOVAL AND INSTALLATION
 
 
Pre-removal and Post-installation Operation
 
 
Removal steps
1.Radiator plug assembly
2.O-ring
3.Radiator cap
4.Hose clip
5.Reservoir tank hose
6.Clip
7.Hose clip
8.Reservoir tank hose A
9.Hose clip
10.Reservoir tank pipe
11.Hose clip
12.Reservoir tank hose B
13.Reservoir tank assembly
14.Hose clip
15.Radiator upper hose B
16.Hose clip
17.Radiator pipe
18.Hose clip
19.Radiator upper hose A
20.Radiator piping clip
21.Hose clip
22.Radiator lower hose B
23.Hose clip
24.Radiator pipe
25.Hose clip
26.Radiator lower hose A
27.Radiator piping clip
28.Hose clip
29.Cooling water line hose
Headlight support panel upper (Exterior – Loose Panel Removal and Installation REMOVAL AND INSTALLATION)
EV oil cooler upper bracket (Electric Power Train – EV Cooling System, EV Oil Cooler Removal and Installation EV OIL COOLER REMOVAL AND INSTALLATION)
Rear Side Air Guide LH / Rear Side Air Guide RH / Air Guide Lower (Ventilation, Heater & Air Conditioner – Heater & Air Conditioner system, Condenser assembly Removal and Installation Removal and Installation)
30.Radiator clip
31.Radiator upper bracket
32.Radiator support upper insulator
33.Radiator assembly
34.Radiator support lower insulator
35.Blower assembly
36.Cooling fan shroud
 
 
REMOVAL SERVICE POINT
 
 
<<A>> HEADLIGHT SUPPORT PANEL UPPER REMOVAL
1. Hang the front power drive unit using the special tool engine hanger (MB991895) and two piece of engine hanger attachment (MB992906) to hold the power drive unit.
2. Remove the mounting bolts from the power drive unit bracket and power drive unit bracket stay, and disconnect the front power drive unit and headlight support panel upper.
3. Leaving the hood latch mounted on the headlight support panel upper, keep away from the headlight support panel upper as shown in the figure.
4. When removing the radiator, use string, etc. to fasten it to the vehicle body so that the oil cooler and EV cooler do not drop off. Also, to protect the cooling fins, wrap them with cushioning material such as cardboard.
noteDo not remove the headlight support panel upper. Instead, keep it within the engine compartment so it does not interfere with work.