[Previous][Next]
REMOVAL AND INSTALLATION
 
 
caution
  • Disconnect the battery (-) terminal and wait for 60 seconds or more before starting work. Insulate the disconnected (-) terminal by wrapping a tape.
  • Handle the front impact sensor with sufficient caution, and do not drop the sensor or allow contact with water, oil, or others. If a dent, crack, deformation and others are discovered, replace it with a new one.
  • The parts indicated by * indicates parts which should be temporarily tightened, and then fully tightened with the vehicle standing on the ground at curb weight.
Front end upper bar assembly removal steps
Front bumper assembly (Refer to GROUP 51, Front Bumper Assembly )
>>C<<1.Front end upper bar assembly
Front suspension strut stiffener plate removal steps
Strut tower bar (Refer to )
2.Front suspension strut stiffener plate (LH)
3.Front suspension strut stiffener plate (RH)
Front end side panel removal steps
4.Front end side panel (LH)
5.Front end side panel (RH)
Battery bracket removal steps
Battery tray (Refer to GROUP 54A, Battery )
>>B<<6.Battery bracket A
>>B<<7.Battery bracket B
Upper frame to front pillar brace removal steps
Fender (Refer to )
8.Upper frame to front pillar brace
Front dash panel insulator removal steps
9.Front dash panel insulator
Side sill inner gusset removal steps
10.Side sill inner gusset
Under cover bracket removal steps
11.Under cover bracket
Body loose panel bracket removal steps
Second seat assembly (Refer to GROUP 52A, Rear Seat )
12.Body loose panel bracket (LH)
13.Body loose panel bracket (RH)
Tie down hook rear removal steps
14.Tie down hook rear
Rear bumper reinforcement removal steps
Rear bumper assembly (Refer to GROUP 51, Rear Bumper Assembly )
>>A<<15.Rear bumper beam
Rear bumper lower bracket removal steps
Rear bumper assembly (Refer to GROUP 51, Rear Bumper Assembly )
>>A<<16.Rear bumper lower bracket
Rear bumper reinforcement removal steps
Quarter trim lower (Refer to GROUP 52A, Interior Trim )
17.Rear end brace (LH)
18.Rear end brace (RH)
Tie down hook rear removal steps
19.Tie down hook rear
Center pillar brace removal steps
20.Center pillar brace
 
 
INSTALLATION SERVICE POINTS
 
 
>>A<< REAR BUMPER BEAM INSTALLATION
Tighten the rear bumper beam bolts in the numerical order to 20 ± 5 N·m (15 ± 3 ft-lb).
 

 
 
>>B<< BATTERY BRACKET A, B INSTALLATION
Tighten the battery bracket A, B bolts in the numerical order to 24 ± 4 N·m (18 ± 2 ft-lb).
 

 
 
>>C<< FRONT END UPPER BAR ASSEMBLY INSTALLATION
Tighten the front end upper bar assembly bolts in the numerical order to 12 ± 2 N·m (106 ± 17 in-lb).