[Previous][Next]
REMOVAL AND INSTALLATION
 
 
Removal steps
1.Headrestraint
Rear scuff plate (Refer to ).
2.Rear seat anchor cover front
3.Rear seat anchor cover rear
4.Wiring harness connector connection [heated seat (rear)]
>>A<<5.Rear seat assembly
 
 
INSTALLATION SERVICE POINT
 
 
>>A<< REAR SEAT ASSEMBLY INSTALLATION
1. Insert the seat pins to holes of the body securely.
2. Confirm that both the seat slides are locked, and then temporarily tighten the front side bolts so that no load is applied to the seat cushion.
3. Tighten the front side bolts to the specified torque.
Tightening torque: 43 ± 8 N·m (32 ± 5 ft-lb)
4. Move the seat forward.
5. Confirm that both the seat slides are locked, and then temporarily tighten the rear side bolts so that no load is applied to the seat cushion.
6. Tighten the rear side bolts to the specified torque.
Tightening torque:
  • M10: 43 ± 8 N·m (32 ± 5 ft-lb)
  • M12: 75 ± 19 N·m (55 ± 14 ft-lb)