[Previous][Next]
REMOVAL AND INSTALLATION
 
 
Pre-removal Operation
  • Radiator Grill Removal (Refer to ).
  • Overfender (Front Bumper Molding) Removal (Refer to ).
  • Engine Room Under Cover Front A Removal (Refer to ).
  • Front Wiring Harness and Front Bumper Wiring Harness Combination Connector
Post-installation Operation
  • Front Wiring Harness and Front Bumper Wiring Harness Combination Connector
  • Engine Room Under Cover Front A Installation (Refer to ).
  • Overfender (Front Bumper Molding) Installation.(Refer to ).
  • Radiator Grill Installation (Refer to ).
  • Front Fog Light Aiming Adjustment (Refer to GROUP 54A, Fog Light - On-vehicle Service ).
Removal steps
Splash shield mounting clips
>>B<<1.Front bumper assembly
2.Front bumper side bracket
3.Front bumper reinforcement stay
4.Air guide upper panel
5.Front bumper center reinforcement side bracket
>>A<<6.Front end upper bar assembly
7.Front bumper beam assembly
 
 
INSTALLATION SERVICE POINTS
 
 
>>A<< FRONT END UPPER BAR ASSEMBLY INSTALLATION
Tighten the front end upper bar assembly bolts in the numerical order to 5.0 ± 2.0 N·m (44 ± 17 in-lb).
 

 
 
>>B<< FRONT BUMPER ASSEMBLY INSTALLATION
  1. Align the headlight boss with the hole of front bumper.
  2. Tighten the front bumper assembly bolts in the numerical order to 5.0 ± 2.0 N·m (44 ± 17 in-lb).