[Previous][Next]
REMOVAL AND INSTALLATION
 
 
Pre-removal and Post-installation Operation
  • Rear Combination Light Assembly Removal and Installation (Refer to GROUP 54A, Rear Combination Light ).
  • Overfender (Rear Bumper Molding) Removal and Installation (Refer to ).
  • Splash Shield Rear (rear bumper side) Removal and Installation (Refer to GROUP 42A, Splash Shield ).
  • Damper Removal and Installation (Refer to GROUP 42A, Liftgate ).
  • Rear End Wiring Harness and Rear Bumper Wiring Harness Combination Connector
Removal steps
1.Bolt (overfender side)
2.Bolt (liftgate lower side)
3.Bolt (liftgate upper side)
>>A<<4.Rear bumper assembly
5.Rear bumper face support bracket
 
 
INSTALLATION SERVICE POINT
 
 
>>A<< REAR BUMPER ASSEMBLY INSTALLATION <VEHICLES WITH BLIND SPOT WARNING AND REAR CROSS TRAFFIC ALERT>
cautionDo not apply any sticker, paint or putty to the radar electric wave penetration area (shaded potion). Avoid any shocks or scratches.
The electric wave penetration areas are symmetrical on left and right.