When servicing the high voltage system parts, always shut off the high voltage by removing the service plug (Refer to Precautions on How to Use the High-voltage Vehicle PRECAUTIONS ON HOW TO USE THE HIGH-VOLTAGE VEHICLE)
Dash panel heat protector removal and installation(Refer to loose panelREMOVAL AND INSTALLATION)
Removal steps
1.
Heater hose H connection
2.
Heater hose I connection
3.
Heater hose M connection
4.
Heater hose N connection
5.
Heater water valve
REMOVAL SERVICE POINT
<<A>> HEATER HOSE CONNECTION
Align to the matching mark (white paint) on the heater hose, draw an alignment mark on the hose clamp, and then disconnect.
INSTALLATION SERVICE POINTS
>>A<< HEATER HOSE / JOINT HOSE CONNECTION
<JOINT HOSE>
1. Insert the heater hose to the protruding section of the joint hose and align the matching mark (white paint) of the heater hose to the protruding section.
2. Align the matching mark that was drawn on the hose clamp when disconnecting with the matching mark on the heater hose, and attach the hose clamp.
<EXCEPT JOINT HOSE>
Align the matching mark that was drawn on the hose clamp when disconnecting with the matching mark on the heater hose, and attach the hose clamp.
![[Previous]](../../../buttons/fprev.png)
![[Next]](../../../buttons/fnext.png)
)
)
)
