Work Procedure
Always perform the front camera unit configuration after replacing the front camera unit.
Always perform the camera aiming after removing and installing or replacing the front camera unit.
caution
The system does not operate normally unless the front camera unit configuration and the camera aiming adjustment are performed. Always perform them.
1.
FRONT CAMERA UNIT CONFIGURATION
Perform the front camera unit configuration with M.U.T.-III SE. Refer to
Work Procedure
.
:
.
2.
CAMERA AIMING ADJUSTMENT
Perform the camera aiming adjustment with M.U.T.-III SE. Refer to
Work Procedure
.
:
.
3.
PERFORM SELF-DIAGNOSIS
Perform the self-diagnosis of front camera unit with M.U.T.-III SE. Check if any DTC is detected.
Is any DTC detected?
Perform the trouble diagnosis for the detected DTC. Refer to DTC Index
DTC Index
.
.
4.
ACTION TEST
Perform the following system action test.
LDW: Refer to Work Procedure
Inspection Procedure
.
LDP: Refer to Work Procedure
Inspection Procedure
.
Active Blind Spot Assist [ABSA]: Refer to
Work Procedure
.
TSR: Refer to
Work Procedure
.
Check that the each system operates normally.
:
WORK END