[Previous][Next]
Inspection Procedure
warningBe careful of traffic conditions and safety around the vehicle when performing road test.
caution
  • Fully understand the following items well before the road test;
1.CHECK LDP SYSTEM SETTING
  1. Start the engine.
  2. Check that the LDP system setting can be enabled/disabled on the information display.
  3. Turn OFF the ignition switch and wait for 30 seconds or more.
  4. Check that the previous setting is saved when the engine starts again.
: .
 
2.ACTION TEST FOR LDP
  1. Enable the setting of the LDP system on the information display.
  2. Turn LDP system display ON.
  3. Check the LDP operation according to the following table.
    7 inch Information Display
    ConditionActionDisplay on information displaySteering vibration
    LDP OFF
    OFF
    LDP ONVehicle speed is less than approx. 60 km/h (37 MPH)White
    OFF
    LDP system indicator: White
    Dynamic driver assistance icon: White
    Vehicle speed is approx. 60 km/h (37 MPH) or moreVehicle closes to lane markerTurn signal is OFF or ON (Opposite to the deviate side)Yawing control is ONYellow (Blink)
    ON
    LDP system indicator: Yellow (Blink)
    Dynamic driver assistance icon: White
    Turn signal is ON (Deviate side)LDP system indicator: White
    Dynamic driver assistance icon: White
    OFF
    Vehicle closes to lane marker with soft brakingYawing control is ONYellow (Blink)
    ON
    LDP system indicator: Yellow (Blink)
    Dynamic driver assistance icon: White
    FULL TFT METER
    ConditionActionDisplay on information displaySteering vibration
    LDP OFF
    OFF
    LDP ONVehicle speed is less than approx. 60 km/h (37 MPH)LDP system indicator: White
    Speaker icon : White
    OFF
    Vehicle speed is approx. 60 km/h (37 MPH) or moreVehicle closes to lane markerTurn signal is OFF or ON (Opposite to the deviate side)Yawing control is ONYellow (Blink)
    ON
    LDP system indicator: Yellow (Blink)
    Speaker icon : White
    Turn signal is ON (Deviate side)LDP system indicator: White
    Speaker icon : White
    OFF
    Vehicle closes to lane marker with soft brakingYawing control is ONYellow (Blink)
    ON
    LDP system indicator: Yellow (Blink)
    Speaker icon : White
    noteAfter the operating conditions of warning are satisfied, the warning continues until the vehicle speed reaches approximately 60 km/h (37 MPH). Refer to System Description.
: INSPECTION END