[Previous][Next]
Inspection Procedure
warningBe careful of traffic conditions and safety around the vehicle when performing road test.
caution
1.CHECK LDW SYSTEM SETTING
  1. Start the engine.
  2. Check that the LDW system setting can be enabled/disabled on the information display.
  3. Turn OFF the ignition switch and wait for 30 seconds or more.
  4. Check that the previous setting is saved when the engine starts again.
: .
 
2.ACTION TEST FOR LDW
  1. Enable the setting of the LDW system on the information display.
  2. Turn LDW system ON.
  3. Check the LDW operation according to the following table.
    7 inch Information Display
    ConditionActionDisplay on information displaySteering vibration
    LDW OFF
    OFF
    LDW ONVehicle speed is less than approx. 55 km/h (34 MPH)LDW system indicator : White
    Speaker icon : White
    OFF
    Vehicle speed is approx. 55 km/h (34 MPH) or moreVehicle closes to lane markerTurn signal is OFF or ON (Opposite to the deviate side)Yellow (Blink)
    ON
    LDW system indicator : Yellow (Blink)
    Speaker icon : White
    Turn signal is ON(Deviate side)LDW system indicator : White
    Speaker icon : White
    OFF
    FULL TFT METER
    ConditionActionDisplay on information displaySteering vibration
    LDW OFF
    OFF
    LDW ONVehicle speed is less than approx. 55 km/h (34 MPH)LDW system indicator : White
    Speaker icon : White
    OFF
    Vehicle speed is approx. 55 km/h (34 MPH) or moreVehicle closes to lane markerTurn signal is OFF or ON (Opposite to the deviate side)Yellow (Blink)
    ON
    LDW system indicator : Yellow (Blink)
    Speaker icon : White
    Turn signal is ON(Deviate side)LDW system indicator : White
    Speaker icon : White
    OFF
    noteAfter the operating conditions of warning are satisfied, the warning continues until the vehicle speed reaches approximately 55 km/h (34 MPH). Refer to System Description.
: INSPECTION END