[Previous][Next]
REMOVAL AND INSTALLATION
 
 
Pre-removal operation
Post-installation operation
Door inside handle removal
1.Door inside handle
Door lock assembly removal steps
•Door working hole rear cover (Refer to Door Glass and Regulator REMOVAL AND INSTALLATION)
2.Door outside handle cover
3.Door lock key cylinder (driver's side)
4.Door outside handle
5.Door outside handle gasket
6.Door outside handle base
7.Front door lock indicator rod
8.Clip
9.Door lock and cable assembly
10.Door lock assembly
11.Door inside handle cable
12.Door outside handle rod
Door check removal
13.Door check
Door inside handle removal
1.Door inside handle
Door lock assembly removal steps
•Door working hole rear cover (Refer to Door Glass and Regulator REMOVAL AND INSTALLATION)
2.Door outside handle cover
3.Door outside handle
4.Door outside handle gasket
5.Door outside handle base
•Door window glass rear lower sash (Refer to REMOVAL AND INSTALLATION)
6.Door lock and cable assembly
7.Door lock assembly
8.Door inside lock cable
9.Door inside handle cable
10.Door outside handle rod
Door check removal
11.Door check
 
 
INSTALLATION SERVICE POINTS
 
 
>>A<< DOOR CHECK INSTALLATION
Install the door check with the following identification mark facing upward.
 
ApplicationIdentification mark
Front doorLeft doorFL
Right doorFR
Rear doorLeft doorRL
Right doorRR
 
 
 
>>B<< DOOR INSIDE HANDLE CABLE INSTALLATION
1. Insert the end of the cable from direction A shown in the figure to install it.
2. Install the casing cap of the cable to B shown in the figure of the door inside handle.
 
 
 
>>C<< DOOR OUTSIDE HANDLE BASE INSTALLATION
1. As shown by A in the figure, securely insert the door outside handle rod into the hole of the clip on the door outside handle base.
2. As shown by B in the figure, turn the clip to fit it into the rod.