REMOVAL AND INSTALLATION
<Front door>
Post-installation Operation
Door Inside Handle Check (Refer to
DOOR INSIDE HANDLE PLAY ADJUSTMENT
).
Removal steps
1.
Door corner cover
2.
Front door pocket cushion
3.
Pull handle cap
4.
Front door finisher assembly
Required Special Tool:
MB990784: Ornament Remover
<Rear door>
Post-installation Operation
Door Inside Handle Check (Refer to
DOOR INSIDE HANDLE PLAY ADJUSTMENT
).
Removal steps
1.
Rear door pocket cushion
2.
Pull handle cap
3.
Rear door finisher assembly
Required Special Tool:
MB990784: Ornament Remover
REMOVAL SERVICE POINTS
<<A>> FRONT DOOR FINISHER ASSEMBLY REMOVAL
1.
Insert ornament remover (Special tool: MB990784) in the slit of the front door finisher assembly, and lift the front door finisher assembly.
2.
Remove the clips shown in the figure using ornament remover (Special tool: MB990784).
3.
Disconnect the inside handle and the front door inside handle cable as shown in the figure.
<<B>> REAR DOOR FINISHER ASSEMBLY REMOVAL
1.
Insert ornament remover (Special tool: MB990784) in the slit of the rear door finisher assembly, and lift the rear door finisher assembly.
2.
Remove the clips shown in the figure using ornament remover (Special tool: MB990784).
3.
Disconnect the inside handle and the rear door inside handle cable as shown in the figure.
4.
Disconnect the rear door inside lock rod and the rear door inside lock rod cable as shown in the figure.
INSTALLATION SERVICE POINTS
>>A<< FRONT DOOR FINISHER ASSEMBLY INSTALLATION
Connect the inside handle and the front door inside handle cable as shown in the figure.
>>B<< REAR DOOR FINISHER ASSEMBLY INSTALLATION
1.
Connect the rear door inside lock rod and the rear door inside lock rod cables as shown in the figure.
2.
Connect the inside handle and the rear door inside handle cable as shown in the figure.
![[Previous]](../../../buttons/fprev.png)
![[Next]](../../../buttons/fnext.png)
).)
).)
)
)
)
)
)
)
)
)
)
)