[Previous][Next]
REMOVAL AND INSTALLATION
 
 
Pre-removal operation
Post-installation operation
Door window glass assembly removal steps
1.Door working hole front cover
2.Door working hole rear cover
3.Door window glass assembly
Power window regulator assembly removal steps
1.Door working hole front cover
2.Door working hole rear cover
3.Door window glass assembly
Power window regulator motor connector connection
4.Power window regulator assembly
Power window regulator motor removal steps
1.Door working hole front cover
2.Door working hole rear cover
3.Door window glass assembly
Power window regulator motor connector connection
4.Power window regulator assembly
5.Power window regulator motor
noteFor removal and installation of the power window switch, refer to Door Finisher REMOVAL AND INSTALLATION.
Door window glass removal steps
1.Door working hole front cover
2.Door working hole rear cover
Rear door sash cover rear (Refer to Door Sash Cover REMOVAL AND INSTALLATION)
Door window glass rear lower sash (Refer to Window Glass Runchannel and Door Opening Weatherstrip REMOVAL AND INSTALLATION)
3.Door window glass assembly
Power window regulator assembly removal steps
1.Door working hole front cover
2.Door working hole rear cover
Rear door sash cover rear (Refer to Door Sash Cover REMOVAL AND INSTALLATION)
Door window glass rear lower sash (Refer to Window Glass Runchannel and Door Opening Weatherstrip REMOVAL AND INSTALLATION)
3.Door window glass assembly
4.Power window regulator assembly
Power window regulator motor removal steps
1.Door working hole front cover
2.Door working hole rear cover
Rear door sash cover rear (Refer to Door Sash Cover REMOVAL AND INSTALLATION)
Door window glass rear lower sash (Refer to Window Glass Runchannel and Door Opening Weatherstrip REMOVAL AND INSTALLATION)
3.Door window glass assembly
4.Power window regulator assembly
5.Power window regulator motor
noteFor removal and installation of the power window switch, refer to Door Finisher REMOVAL AND INSTALLATION.
 
 
Required Special Tool:
  • MB990480 Glass Holder
 
 
REMOVAL SERVICE POINT
 
 
<<A>> DOOR WINDOW GLASS ASSEMBLY/ POWER WINDOW REGULATOR ASSEMBLY REMOVAL
1. Align the glass holder mounting bolt on the door window glass with the service hole to remove it.
cautionIf any film or the like is applied to a door window glass, use the glass holder (Special tool: MB990480) at the outside of the door glass to prevent the film from peeling off.
2. Lift the door window glass, and attach the glass holder (Special tool: MB990480) to the glass as shown to prevent the glass from falling <Rear door>.
3. Slant the door window glass and remove it upward from the inside of the door <Rear door>.
4. Remove the power window regulator assembly.