[Previous][Next]
DOOR WINDOW GLASS ADJUSTMENT
Check that a door window glass operates smoothly and moves along the door window glass runchannel when the window glass is fully raised and lowered. If there is a problem, adjust the window glass by the following procedures:
1. Remove the door finisher assembly (Refer to Door Finisher REMOVAL AND INSTALLATION).
2. Remove the plug from the service hole.
3. Remove the working hole rear cover (Refer to REMOVAL AND INSTALLATION).
4. Remove the power window switch from the removed door trim assembly, and connect it to the door side connector.
5. Set the glass holder mounting bolts to the service hole.
6. Raise the window glass with the power window switch to check that the window glass to door clearance is even. If there is a problem, loosen the glass holder mounting bolts to adjust tilting up/down of the glass.
7. Install the working hole rear cover (Refer to REMOVAL AND INSTALLATION).
8. Install the plug from the service hole.
9. Install the door finisher assembly (Refer to Door Finisher REMOVAL AND INSTALLATION).