[Previous][Next]
REMOVAL AND INSTALLATION
 
 
Removal steps
1.Tonneau cover assembly
2.Luggage rear plate mask
3.Luggage rear plate
Rear kicking plate (Refer to REMOVAL AND INSTALLATION).
Liftgate opening weatherstrip (Refer to REMOVAL AND INSTALLATION <Vehicles without power liftgate> or REMOVAL AND INSTALLATION <Vehicles with power liftgate>).
4.Rear seatback release lever cap
5.Luggage side lower finisher assembly
6.Seatback remote release lever cable connection
7.Luggage side lower finisher bracket
8.Rear wheelhouse silencer
9.Luggage side upper finisher cap
Outer seat belt <THIRD SEAT BELT>(Refer to Removal and Installation).
Seat belt with pre-tensioner (Refer to Removal and Installation).
10Luggage side upper finisher
Required Special Tool:
  • MB990784: Ornament Remover
 
 
REMOVAL SERVICE POINTS
 
 
<<A>> LUGGAGE REAR PLATE REMOVAL
Remove the clips shown in the figure using ornament remover (Special tool: MB990784).
 
 
 
<<B>> LUGGAGE SIDE LOWER FINISHER ASSEMBLY REMOVAL
1. Disengage the seat lever control cable assembly and the luggage side lower finisher assembly.
2. Remove the clips and release the claws shown in the figure using ornament remover (Special tool: MB990784).
3. Leave the seatback remote release lever cable assembly on the second seat assembly side and remove the luggage side lower finisher assembly.
 
 
 
<<C>> LUGGAGE SIDE UPPER FINISHER REMOVAL
Remove the clips shown in the figure using ornament remover (Special tool: MB990784).