[Previous][Next]
REMOVAL AND INSTALLATION
 
 
<Floor trim>
Removal steps
1.Front kicking plate
Hood lock release handle (Refer to REMOVAL AND INSTALLATION.)
2.Dash side finisher
3.Rear kicking plate
 
 
<Pillar trim>
Removal steps
Door opening inner weatherstrip (Refer to REMOVAL AND INSTALLATION.)
1.Front pillar garnish
2.Front pillar garnish clip
3.Seat belt cover
4.Center pillar lower garnish
5.Center pillar upper garnish
 
 
REMOVAL SERVICE POINT
 
 
<<A>> FRONT PILLAR GARNISH REMOVAL
Cut the front pillar garnish clip at the cutting position shown in the figure, and remove the front pillar garnish.
 
 
 
 
INSTALLATION SERVICE POINT
 
 
>>A<< FRONT PILLAR GARNISH CLIP INSTALLATION
Install the clip as shown in the figure while making sure that its hatched part does not protrude from the position of the clip base.
 
 
 
 
<Cargo room trim>
Removal steps
1.Luggage floor board
2.Luggage box
Bounce the third seat back.
3.Luggage floor box <Flat tire temporary repair kit>
Speaker box assembly
Speaker support
4.Luggage floor box <Flat tire temporary repair kit (Sub woofer)>