[Previous][Next]
REMOVAL AND INSTALLATION
 
 
Pre-removal Operation
Post-installation Operation
Liftgate assembly removal steps
1.Liftgate opening weatherstrip
Liftgate lower inner finisher (Refer to Liftgate Trim REMOVAL AND INSTALLATION)
2.Ground bolt
3.Liftgate wiring harness connector connection
4.Power liftgate control unit assembly
5.Liftgate assembly
Headlining (Refer to Headlining REMOVAL AND INSTALLATION).
6.Liftgate hinge
7.Liftgate upper weatherstrip
8.Liftgate damper upper
9.Shim <Vehicles with shim>
10.Liftgate damper lower
11.Damper
 
 
INSTALLATION SERVICE POINTS
 
 
>>A<< LIFTGATE HINGE INSTALLATION
Apply the specified sealant to the liftgate hinge mounting surface, and install the liftgate hinge.
Specified Adhesive: 3M™ AAD Part No.8531 Heavy drip check sealer, 3M™ AAD Part No.8646 Automotive joint and seam sealer or equivalent
 
 
 
>>B<< GROUND BOLT INSTALLATION
Check the head mark "E" and install the ground bolt.
 
 
 
>>C<< LIFTGATE OPENING WEATHERSTRIP INSTALLATION
The marking on the liftgate opening weatherstrip should be positioned at the center of the body.