[Previous][Next]
REMOVAL AND INSTALLATION
 
 
cautionBefore removing and installing the headlining, refer to Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" and Removal and Installation.
Pre-removal and Post-installation Operation
<Vehicles with standard roof>
Removal steps
1.Sun visor holder
2.Sun visor
3.Map light assembly
4.Vanity light
5.Vanity light bracket
6.Assist grip
7.Map light assembly
FCM camera cover (Refer to Removal and Installation).
8.Headlining
9.Assist grip bracket
10.Map light bracket
11.Map light bracket
12.Roof sub wiring harness
<Vehicles with sunroof>
Removal steps
1.Sun visor holder
2.Sun visor
3.Map light assembly
4.Vanity light
5.Vanity light bracket
6.Assist grip
FCM camera cover (Refer to Removal and Installation).
7.Headlining
8.Assist grip bracket
9.Map light bracket
10.Personal light Assembly
11.Personal light bracket
12.Roof sub wiring harness
Required Special Tool:
  • MB990784: Ornament Remover
 
 
REMOVAL SERVICE POINTS
 
 
<<A>> SUN VISOR HOLDER REMOVAL
Insert ornament remover (Special tools: MB990784) into the sun visor holder from its left and right sides to disengage the claws on the sun visor holder sides.
 

 
 
<<B>> SUN VISOR REMOVAL
1. Lift the lock cover bracket.
2. Remove the sun visor shown in the figure using a flat-tipped screwdriver.
cautionBe careful not to damage to the wiring harness of the vanity light.
3. Remove the claws shown in the figure using ornament remover (Special tool: MB990784).
 

 
 
<<C>> MAP LIGHT ASSEMBLY REMOVAL
The map light assembly has clips on the front side and insertion type tabs on the rear side. Therefore, insert ornament remover (Special tool: MB990784) from the front side to remove the map light assembly.
 

 
 
<<D>> VANITY LIGHT REMOVAL
Remove the vanity light by moving it toward the direction of the arrow (A) shown in the figure.
 

 
 
<<E>> ASSIST GRIP REMOVAL
1. Remove the assist grip.
2. Grab the position shown in the figure of the sheet metal clip with pliers, and remove the clip.
 

 
 
<<F>> HEADLINING REMOVAL
1. Peel off dual lock fasteners between headlining assembly and roof panel.
2. To remove the clip, insert a vinyl cord into a clearance between the clip and the headlining, and pass it around the clip. Then, pull out the clip downwards while pulling the vinyl cord.
3. Carry out the headlining assembly from the liftgate opening while deflecting the headlining.
 

 
 
<<G>> PERSONAL LIGHT ASSEMBLY REMOVAL
Remove the personal light by moving it toward the direction of the arrow (A) shown in the figure.
 
 
 
 
INSTALLATION SERVICE POINTS
 
 
>>A<< ASSIST GRIP REMOVAL INSTALLATION
1. Attach the sheet metal clip to the assist grip.
2. Attach the assist grip to the mounting location.
 
 
>>B<< SUN VISOR INSTALLATION
1. Attach the sun visor to the mounting location.
2. Push the lock cover bracket shown in the figure, and lock the sun visor.