[Previous][Next]
Removal and Installation
 
 
warning
  • Be sure to check precautions and notes by referring to PRECAUTIONS for SEAT BELT before work.Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
  • Before servicing, ignition switch OFF, disconnect battery negative terminal and wait for 3 minutes or more (discharges electricity held in the additional power supply circuit of the air bag diagnosis sensor unit).
  • Never place seat belt pre-tensioner retractor and lap pre-tensioner in an area where the temperature reaches 80°C (176°F) or more.
Pre-removal Operation
Turn the ignition switch to the "LOCK" (OFF) position.
 
 
<FRONT SEAT BELTS>
Front seat belt pre-tensioner (front seat belt outer) removal steps
Disconnect the negative (-) battery terminal.
Center pillar lower garnish (Refer to Interior Trim REMOVAL AND INSTALLATION)
1.Adjuster cover
2.Front seat belt pre-tensioner (front seat belt outer)
3.Center pillar upper garnish (Refer to Interior Trim REMOVAL AND INSTALLATION)
4.Seat belt adjuster
Front seat belt pre-tensioner (front seat belt outer) installation steps
4.Seat belt adjuster
3.Center pillar upper garnish (Refer to Interior Trim REMOVAL AND INSTALLATION)
2.Front seat belt pre-tensioner (front seat belt outer)
1.Adjuster cover
Center pillar lower garnish (Refer to Interior Trim REMOVAL AND INSTALLATION)
Connect the negative (-) battery terminal.
 
 
<SECOND SEAT BELTS>
Second seat belt pre-tensioner (second seat belt outer) removal steps
Disconnect the negative (-) battery terminal.
Luggage side upper finisher (Refer to Luggage Trim REMOVAL AND INSTALLATION)
1.Second seat belt pre-tensioner (second seat belt outer)
Second seat belt pre-tensioner (second seat belt outer) installation steps
1.Second seat belt pre-tensioner (second seat belt outer)
Luggage side upper finisher (Refer to Luggage Trim REMOVAL AND INSTALLATION)
Connect the negative (-) battery terminal.
 
 
REMOVAL SERVICE POINTS
 
 
<<A>> SEAT BELT PRE-TENSIONER (SEAT BELT OUTER) REMOVAL
Use the flat-tipped screwdriver to pull out the locking button of wiring harness side connector, and release the lock.
 
 
 
 
INSTALLATION SERVICE POINT
 
 
>>A<< SEAT BELT PRE-TENSIONER (SEAT BELT OUTER) INSTALLATION
Insert the claws of the seat belt retractor into the body, and install the seat belt retractor in order of the numbers shown in the figure.