[Previous][Next]
DIAGNOSTIC TROUBLE CODE CHART
caution
  • During troubleshooting, a DTC associated with other system may be set when the ignition switch is turned on with connector(s) disconnected. On completion, check all systems for DTC code(s). If DTC code(s) are set, erase them all.
  • When the combination meter is required to be replaced as a result of the troubleshooting, the current driving distance and number of elapsed days to be used for service reminder function must be entered into the meter after the replacement. Therefore, read "Integrated mileage for reminder," "Integrated days for reminder," "Mileage until Extra reminder," "Months until Extra reminder," and "Current Schedule" from the meter before the replacement using the special function of scan tool MB991958, and note them. For the operation method of scan tool MB991958, refer to . If "Integrated mileage for reminder" or "Integrated days for reminder" cannot be read by the scan tool MB991958, follow the method described below.
    1. For the driving distance for check warning, use the driving distance displayed on the multi information display.
    2. For the elapsed days for check warning, calculate the number of elapsed days from the delivery date to the customer (service remainder function start date) and current date.
DTC No.Diagnostic itemReference page
B1200Malfunction of odometer
B1201Abnormal fuel information<FWD>
<AWD>
B1209Test mode
B2203VIN not programmed
B2463The sticking of rheostat switch
B2464The sticking of meter information switch
B2465Ignition switch signal error
U0019Bus off (CAN-B)
U0100Engine control module CAN timeout
U0141ETACS CAN timeout
U0164A/C/Heater control unit CAN timeout
U0168KOS-ECU or WCM CAN timeout
U1000OSS-ECU CAN timeout
U1415Coding not completed/Data fail