When you remove/install or replace the camera, you should check the camera image on the multi around monitor "Bird’s eye-view." If necessary, calibrate the camera (Refer to ).
To ensure the camera image is clearly visible, wipe the lens with a damped rag and then a dry rag to remove dust, rain drops or snow.
Be careful not to damage the camera. Any damage may have an adverse effect on the screen image.
For how to remove the side view camera, refer to GROUP 51 - Door Mirror Removal and Installation .
<FRONT VIEW CAMERA>
Pre-removal and Post-installation Operation
Front Bumper Assembly Removal and Installation(Refer to GROUP 51 - Front Bumper Assembly ).
Front Bumper Center cover Removal and Installation (Refer to GROUP 51 - Front Bumper Assembly ).
Removal steps
1.
Screw
2.
Front view camera
<REAR VIEW CAMERA>
Pre-removal and Post-installation Operation
Liftgate Trim Removal and Installation (Refer to GROUP 52A - Liftgate Trim ).
![[Previous]](../../../buttons/fprev.png)
![[Next]](../../../buttons/fnext.png)
.)
)