Inspection Procedure 6: The front door switch (passenger’s side) signal is not received.
caution
Before replacing the ECU, ensure that the power supply circuit, the ground circuit and the communication circuit are normal.
When the ETACS-ECU of vehicles without KOS is replaced, the encrypted code of the ignition key needs to be registered to the ETACS-ECU. (If the encrypted code is not registered, the engine cannot be started. Register the encrypted code as described in Immobilizer System - How to Register Key ID .)
TECHNICAL DESCRIPTION (COMMENT)
If there is an error to the front door switch (passenger’s side) input signal, the front door switch (passenger’s side) signal is no longer output to the communication line.
TROUBLESHOOTING HINTS
The front door switch (RH) may be defective
The ETACS-ECU may be defective
The wiring harness or connectors may have loose, corroded, or damaged terminals, or terminals pushed back in the connector
DIAGNOSIS
Required Special Tools:
MB991223: Harness Set
MB992006: Extra Fine Probe
STEP 1. Check the installation condition.
Check that the front door switch (passenger’s side) is installed to the body correctly.
Is the check result normal?
Go to Step 2.
Correct the installation condition.
STEP 2. Front door switch (passenger’s side) check
Refer to GROUP 42A - Door .
Is the check result normal?
Go to Step 3.
Replace the front door switch (passenger’s side).
STEP 3. Check of short to power supply, short to ground, and open circuit in DAS line between ETACS-ECU connector and front door switch (RH) connector
Is the check result normal?
Go to Step 4.
Repair the connector(s) or wiring harness.
STEP 4. Using scan tool (M.U.T.-III), check data list.
(1)
caution
To prevent damage to scan tool (M.U.T.-III), always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool (M.U.T.-III).
Connect scan tool (M.U.T.-III). Refer to "How to connect Scan Tool (M.U.T.-III) ."
(2) Open the front passenger's door.
Item No.
Item name
Normal condition
257
As door ajar switch
Open
Item No.
Item name
Normal condition
257
As door ajar switch
Open
OK: Normal condition is displayed.
Is the check result normal?
The trouble can be an intermittent malfunction (Refer to GROUP 00 - How to use Troubleshooting/inspection Service Points - How to Cope with Intermittent Malfunction ).