[Previous][Next]
DTC U1190: No receive fault detect signal
 
 
caution
  • Before replacing the ECU, ensure that the power supply circuit, the ground circuit and the communication circuit are normal.
  • When the ETACS-ECU of vehicles without KOS is replaced, the encrypted code of the ignition key needs to be registered to the ETACS-ECU. (If the encrypted code is not registered, the engine cannot be started. Register the encrypted code as described in Immobilizer System - How to Register Key ID .)
 
 
JUDGMENT CRITERIA
ETACS-ECU sends DTC (U code) detection permission or prohibition signal to each ECU connected to the CAN bus line. If the combination meter cannot receive DTC (U code) detection permission or prohibition signal for 5 seconds after turning the ignition switch to ON position, DTC U1190 will be set.
 
 
TROUBLESHOOTING HINTS
  • The CAN bus line may be defective.
  • The ETACS-ECU may be defective.
 
 
DIAGNOSIS
STEP 1. Using scan tool (M.U.T.-III), diagnose the CAN bus line
(1)
cautionTo prevent damage to scan tool (M.U.T.-III), always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool (M.U.T.-III).
Connect scan tool (M.U.T.-III). Refer to "How to connect the Scan Tool (M.U.T.-III) ."
(2) Turn the ignition switch to the "ON" position.
(3) Diagnose the CAN bus line.
(4) Turn the ignition switch to the "LOCK" (OFF) position.
Is the CAN bus line found to be normal?
Go to Step 2.
Repair the CAN bus line (Refer to GROUP 54C, Diagnosis ).
 
STEP 2. Using scan tool (M.U.T.-III), read the ETACS diagnostic trouble code
Check if DTC is set in the ETACS-ECU.
Is the DTC set?
Diagnose the ETACS-ECU (Refer to ).
Go to Step 3
 
STEP 3. Using scan tool (M.U.T.-III), read the KOS diagnostic trouble code.
Check if DTC No. U1190 is set in KOS-ECU.
Is the DTC set?
Go to Step 4.
Go to Step 5.
 
STEP 4. Recheck for diagnostic trouble code.
Recheck if the DTC is set.
(1) Erase the DTC.
(2) Turn the ignition switch to "ON" position.
(3) On completion, check that the DTC is not set again.
Is the DTC set?
Replace ETACS-ECU and then go to Step 6.
A poor connection, open circuit or other intermittent malfunction is present in the CAN bus lines between the ETACS-ECU and the combination meter (Refer to GROUP 00 - How to use troubleshooting/Inspection Service Points ).
 
STEP 5. Recheck for diagnostic trouble code.
Recheck if the DTC is set.
(1) Erase the DTC.
(2) Turn the ignition switch to "ON" position.
(3) On completion, check that the DTC is not set again.
Is the DTC set?
Replace combination meter and then go to Step 6.
A poor connection, open circuit or other intermittent malfunction is present in the CAN bus lines between the ETACS-ECU and the combination meter (Refer to GROUP 00 - How to use troubleshooting/Inspection Service Points ).
 
STEP 6. Recheck for diagnostic trouble code.
Recheck if the DTC is set.
(1) Erase the DTC.
(2) Turn the ignition switch to "ON" position.
(3) On completion, check that the DTC is not set again.
Is the DTC set?
Go to Step 1.
The procedure is complete.