STEP 1. Using scan tool (M.U.T.-III), read the combination meter diagnostic trouble code.
(1) caution | To prevent damage to scan tool (M.U.T.-III), always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool (M.U.T.-III). |
Connect scan tool (M.U.T.-III). Refer to "How to connect the Scan Tool (M.U.T.-III)
."
(2) Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
(3) Check if DTC No. B1201 is stored.
Is DTC No. B1201 stored?
Follow the relevant DTC procedure (Refer to ). Go to Step 2.
STEP 2. Fuel pump module and fuel level sensor (sub) <AWD> check
STEP 3. Using scan tool (M.U.T.-III), check data list
STEP 4. Using scan tool (M.U.T.-III), check actuator test
STEP 5. Retest the system.