[Previous][Next]
DTC B1418: Front impact sensor (LH) communication error
DTC B1419: Front impact sensor (LH) communication impossible
 
 
cautionIf DTC B1418 or B1419 is stored in the SRS-ECU, always diagnose the CAN main bus line.
 
 
CIRCUIT OPERATION
The front impact sensor (LH) transmits acceleration data to the SRS-ECU. The SRS-ECU then determines whether to operate the front air bags, and then outputs an ignition signal when necessary. The front impact sensor also diagnoses itself, and sends a diagnostic trouble code to the SRS-ECU if a malfunction occurs.
 
 
DTC SET CONDITIONS
The DTC is stored if the communication between the front impact sensor (LH) and SRS-ECU is abnormal (No. B1418), or impossible (No. B1419).
 
 
TROUBLESHOOTING HINTS
  • Damaged wiring harnesses or connectors
  • Malfunction of the front impact sensor (LH)
  • Malfunction of the SRS-ECU
 
 
DIAGNOSIS
STEP 1. Using scan tool (M.U.T.-III), diagnose the CAN bus line.
(1)
cautionTo prevent damage to scan tool (M.U.T.-III), always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool (M.U.T.-III).
Connect scan tool (M.U.T.-III). Refer to "How to connect the scan tool ."
(2) Turn the ignition switch to the "ON" position.
(3) Diagnose the CAN bus line.
(4) Turn the ignition switch to the "LOCK" (OFF) position.
Is the CAN bus line found to be normal?
Go to Step 2.
Repair the CAN bus line (Refer to GROUP 54C, Diagnosis ). Then go to Step 2.
 
STEP 2. Recheck for diagnostic trouble code.
Check again if the DTC is stored.
(1) Erase the DTC.
(2) Turn the ignition switch to the "ON" position.
(3) Check if the DTC is stored.
(4) Turn the ignition switch to the "LOCK" (OFF) position.
Is the DTC stored?
Go to Step 3.
There is an intermittent malfunction such as poor engaged connector(s) or open circuit (Refer to GROUP 00, How to Cope with Intermittent Malfunction ).
 
STEP 3. Check the front impact sensor (LH).
(1) Check that the negative battery terminal is disconnected. If the negative battery terminal is connected, disconnect it.
(2) Alternate the front impact sensor (LH) and the front impact sensor (RH), and then install the alternated sensor.
(3) Connect the negative battery terminal.
(4) After erasing the DTC memory, check the DTC again.
(5) Disconnect the negative battery terminal.
Is DTC No. B1418 or B1419 stored?
Replace the front impact sensor (LH) with a new one (Refer to ).
Go to Step 4.
 
STEP 4. Check of short to power supply, short to ground, and open circuit in FLH-, FLH+ line between SRS-ECU connector and front impact sensor (LH) connector.
Is the check result normal?
Go to Step 5.
Repair the wiring harness.
 
STEP 5. Recheck for diagnostic trouble code.
Check again if the DTC is stored.
(1) Erase the DTC.
(2) Turn the ignition switch to the "ON" position.
(3) Check if the DTC is stored.
(4) Turn the ignition switch to the "LOCK" (OFF) position.
Is DTC B1418 or B1419 stored?
Replace SRS-ECU (Refer to ).
Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction ).