[Previous][Next]
DTC U1195 Coding not completed
DTC U1197 Coding data unavailable
 
 
caution
  • If there is any problem in the CAN bus lines, an incorrect DTC may be set. Prior to this diagnosis, diagnose the CAN bus lines (Refer to GROUP 54C, CAN Bus Diagnostics Table ).
  • Whenever ECU is replaced, ensure that the CAN bus lines are normal.
 
 
OPERATION
EPS-ECU receives variant coding data from the ETACS-ECU.
 
 
 
FUNCTION
The coding data is sent to the EPS-ECU for motor control.
 
 
 
TROUBLE JUDGMENT
Check Conditions
  • The power supply circuit system DTC (No. C1540, C1541) is not set.
  • The ETACS circuit system DTC is not set.
Judgment Criterion
  • The electric power steering-ECU coding is not completed.
  • The abnormal coding data is sent from the ETACS-ECU, and the microcomputer determines that there is a problem in the system.
Fail Safe, Back Up Function
  • The EPS-ECU prohibits the motor control, and sets DTCs No. U1195 and U1197.
 
 
 
TROUBLESHOOTING HINTS
  • Malfunction of CAN bus line
  • Malfunction of the EPS-ECU
  • Malfunction of the ETACS-ECU
 
 
 
 
DIAGNOSIS
STEP 1. Scan tool (M.U.T.-III) CAN bus diagnostics
(1)
cautionTo prevent damage to scan tool (M.U.T.-III), always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool (M.U.T.-III).
Connect scan tool (M.U.T.-III). Refer to "How to connect the Scan Tool (M.U.T.-III) ."
(2) Turn the ignition switch to the "ON" position.
(3) Diagnose the CAN bus line.
(4) Turn the ignition switch to the "LOCK" (OFF) position.
Is the check result normal?
Go to Step 3.
Repair the CAN bus lines (Refer to GROUP 54C - CAN Bus Diagnostics Table ). On completion, go to Step 2.
 
STEP 2. DTC recheck after resetting CAN bus lines
(1) Erase the DTC.
(2) Turn the ignition switch from the "LOCK" (OFF) position to the "ON" position.
(3) Check if the DTC is set.
Is any of DTCs U1195 and U1197 set?
Go to Step 3.
This diagnosis is complete.
 
STEP 3. Scan tool (M.U.T.-III) other system DTC
Use scan tool (M.U.T.-III) to check whether the ETACS-ECU-related or engine ECU-related DTC is set or not.
Is any DTC set?
Troubleshoot for the relevant DTC.
Go to Step 4.
 
STEP 4. Check whether the DTC is set again.
(1) Erase the DTC.
(2) Turn the ignition switch from the "LOCK" (OFF) position to the "ON" position.
(3) Check if the DTC is set.
Is any of DTCs U1195 and U1197 set?
Replace the EPS-ECU (Refer to ). Then go to Step 5.
Intermittent malfunction (Refer to GROUP 00 - How to Cope with Intermittent Malfunction ).
 
STEP 5. Check whether the DTC is set again.
(1) Erase the DTC.
(2) Turn the ignition switch from the "LOCK" (OFF) position to the "ON" position.
(3) Check if the DTC is set.
Is any of DTCs U1195 and U1197 set?
Return to Step 1.
This diagnosis is complete.