[Previous][Next]
DTC No. C1626: Electronic controlled coupling solenoid voltage fails
 
 
 
 
OPERATION
The AWD-ECU monitors the actuator power supply voltage.
 
 
DTC SET CONDITION
This DTC is set when the abnormality below is detected:
  • Electronic control coupling solenoid voltage monitor value: 10 V or more.
 
 
TROUBLESHOOTING HINTS
  • Malfunction of electronic control coupling solenoid
  • Damaged harness wires and connectors
  • Malfunction of AWD-ECU
 
 
DIAGNOSIS
Required Special Tools:
  • MB991223: Harness Set
  • MB992006: Extra Fine Probe
STEP 1. Measure the resistance at the AWD-ECU connector.
(1) Disconnect the connector, and measure at the wiring harness side.
(2) Resistance between AWD-ECU connector terminal SOL+, SOL- and body ground
OK: No continuity
Is the check result normal?
Go to Step 3.
Go to Step 2.
 
STEP 2. Check the wiring harness between electronic control coupling solenoid connector and AWD-ECU connector terminal SOL+, SOL-.
Check the power supply, ground line for short circuit (for short to the power supply).
Is the check result normal?
Go to Step 3.
Repair the defective connector or the wiring harness. Then go to Step 4.
 
STEP 3. Check of the electronic control coupling solenoid
Refer to .
Is the check result normal?
Go to Step 4.
Replace the electronic control coupling (Refer to ). Then go to Step 4.
 
STEP 4. Check whether the DTC is set again.
Is DTC No.C1626 set?
Replace the AWD-ECU (Refer to ). Then go to Step 5.
Intermittent malfunction (Refer to GROUP 00 - How to Cope with Intermittent Malfunction ).
 
STEP 5. Check whether the DTC is set again.
Is DTC No.C1626 set?
Return to Step 1.
This diagnosis is complete.