STEP 1. Check if the EGR valve sounds during initialization.
STEP 2. Using scan tool (M.U.T.-III), read the diagnostic trouble code (DTC)
caution | To prevent damage to scan tool (M.U.T.-III), always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool (M.U.T.-III). |
(1) Connect scan tool (M.U.T-III). Refer to HOW TO CONNECT THE SCAN TOOL (M.U.T.-III) . (2) Turn the ignition switch to the "ON" position.
(3) Read the DTC.
(4) Turn the ignition switch to the "LOCK" (OFF) position.
Is any DTC stored?
Refer to Diagnostic Trouble Code Chart . Go to Step 3.
STEP 3. Using scan tool (M.U.T.-III), check actuator test.
(1) Turn the ignition switch to the "ON" position.
(2) Check the following item in the actuator test. Refer to Actuator Test Reference Table .- Item 10: Evaporative Emission Purge Solenoid
(3) Turn the ignition switch to the "LOCK" (OFF) position.
Is the actuator operating properly?
Go to Step 4. Repair or replace it. Then confirm that the malfunction symptom is eliminated.
STEP 4. Check the spark plugs.
STEP 5. Check the ignition coil.
STEP 6. Check the positive crankcase ventilation system.