[Previous][Next]
ACTUATOR TEST REFERENCE TABLE
note: Continues for 27 minutes. Can be released by pressing the CLEAR key.
M.U.T.-III SCAN TOOL DISPLAYITEM NO.INSPECTION ITEMDRIVE CONTENTSINSPECTION REQUIRMENTNORMAL CONDITION
A/C relay16A/C compressor clutch relayA/C compressor clutch relay turns from OFF to ON.Ignition switch: "ON"Clicks when A/C compressor clutch is driven.
Cooling fan14Radiator fan, A/C condenser fanDrive the fan motor.Ignition switch: "ON"Radiator fan and A/C condenser fan rotate.
EVAP. emission purge SOL. Valve10Evaporative emission purge solenoidSolenoid valve turns from OFF to ON.Ignition switch: "ON"Clicks when solenoid valve is driven.
EVAP. emission ventilation SOL.15Evaporative emission ventilation solenoidSolenoid valve turns from OFF to ON.Ignition switch: "ON"Clicks when solenoid valve is driven.
Fuel pump9Fuel pumpFuel pump operates and fuel is recirculated.
  • Ignition switch: "ON"
  • Listen near the fuel tank for the sound of fuel pump operation.
Sound of operation is heard.
Ignition timing 5 BTDC11*Basic ignition timingSet to ignition timing adjustment mode.
  • Engine: idling
  • Connect timing light
5°BTDC
Injector stop1InjectorsSpecified injector is stopped.Engine: warm up, idle (cut the fuel supply to each injector in turn and check cylinders which don't affect idling.)Idle condition is changed by stopping selected cylinder: this can cause an unstable condition and the engine may stall.
Oil control valve17Oil feeder control valveSwitch the oil feeder control valve from OFF to ON.Engine: warm up, idleWhen the valve is actuated, operating noise is audible.