[Previous][Next]
REMOVAL AND INSTALLATION
 
 
Pre-removal Operation
  • Door Trim Assembly Removal (Refer to GROUP 52A, Door Trim ).
  • Door Working Hole Cover Front Removal (Refer to ).
  • Waterproof Film Removal (Refer to ).
Post-installation Operation
  • Door Window Glass Adjustment (Refer to ).
  • Waterproof Film Installation (Refer to ).
  • Door Working Hole Cover Front Installation (Refer to ).
  • Door Trim Assembly Installation (Refer to GROUP 52A, Door Trim ).
  • Learning Procedures of The Power Window Fully Closed Position (Refer to ).
Removal steps
<<A>>1.Power window regulator assembly
2.Power window regulator motor
3.Power window regulator
4.Door window glass assembly
noteFor removal and installation of the power window switch, refer to GROUP 52A, Door Trim .
Removal steps
<<A>>1.Power window regulator assembly
2.Power window regulator
3.Power window regulator motor
4.Door window glass runchannel
5.Door window rear sash
6.Door stationary window glass weatherstrip assembly
7.Door stationary window glass
8.Door window glass assembly
noteFor removal and installation of the power window switch, refer to GROUP 52A, Door Trim .
 
 
REMOVAL SERVICE POINT
 
 
<<A>> POWER WINDOW REGULATOR ASSEMBLY REMOVAL
1. Align the channel guide mounting bolt on the door window glass with the adjusting hole to remove it.
cautionIf any film or the like is applied to a door window glass, use the window glass holder (Special tool: MB990480) at the outside of the door glass to prevent the film from peeling off.
2. Lift the door window glass, and attach the special tool MB990480 to the glass as shown to prevent the glass from falling.
3. Remove the power window regulator assembly.