Check that a door window glass operates smoothly and moves along the door window glass runchannel when the window glass is fully raised and lowered. If there is a problem, adjust the window glass by the following procedures:1. Remove a door trim assembly (Refer to GROUP 52A, Door Trim 
). 2. Remove a waterproof film (Refer to ). 3. Remove the power window switch from the removed door trim assembly, and connect it to the door side connector.
4. Set the channel guide mounting bolts to the adjusting hole.
5. Raise the window glass with the power window switch to check that the window glass to door clearance is even. If there is a problem, loosen the channel guide mounting bolts to adjust tilting up/down of the glass.
![[Previous]](../../../buttons/fprev.png)
![[Next]](../../../buttons/fnext.png)
)
)