[Previous][Next]
REMOVAL AND INSTALLATION
 
 
Electric parking brake actuator assembly removal steps
1.Electric parking brake actuator assembly connector connection.
>>C<<2.Electric parking brake actuator assembly
>>B<<3.O-ring
Electric parking brake harness assembly removal steps
•Floor console assembly rear (Refer to GROUP 52A - Rear Floor Console Assembly ).
•Front seat assembly (Refer to GROUP 52A - Front Seat Assembly ).
•Rear seat assembly (Refer to GROUP 52A - Rear Seat Assembly ).
•Center pillar trim lower (Refer to GROUP 52A - Trim ).
•Rear floor under cover (Refer to GROUP 51 - Under Cover ).
4.Electric parking brake harness assembly connector connection.
>>C<<1.Electric parking brake actuator assembly connector connection.
5.Bracket
6.Cable clamp
>>A<<7.Electric parking brake harness assembly
8.Electric wiring tape
 
 
INSTALLATION SERVICE POINTS
 
 
>>A<< ELECTRIC PARKING BRAKE HARNESS ASSEMBLY INSTALLATION
Guide the electric parking brake wiring harness assembly so that the markings on the grommets face as shown.
 
 
 
>>B<< O-RING INSTALLATION
cautionThe O-ring cannot be reused. When you reinstall the actuator, replace the O-ring with new one.
Apply grease to the new O-ring, and then install the electric parking actuator to the rear brake caliper assembly.
Specified grease: Repair kit grease, cosmo rubber grease or equivalent
 
 
 
>>C<< ELECTRIC PARKING BRAKE ACTUATOR ASSEMBLY INSTALLATION
cautionCheck if brake fluid leaks from the arrow part.
Install the electric parking actuator to the rear brake caliper assembly, and then tighten the bolt to the specified torque.
Specified torque: 8.4 ± 1.1 N·m (74 ± 9 in-lb)