[Previous][Next]
REMOVAL AND INSTALLATION
 
 
caution
Before removing and installing the front seat assembly, refer to GROUP 52B - Service Precautions and Side-airbag Module .
Removal steps
1.Headrestraint
2.Front seat anchor side shield cover front
3.Front seat anchor backbone cover front
4.Front seat anchor side shield cover rear
5.Front seat anchor backbone cover rear
<<A>>6.Wiring harness connector connection [side-airbag module, front seat belt switch, seat slide sensor, occupant classification-ECU, heated seat (front), power seat]
>>A<<7.Front seat assembly
 
 
REMOVAL SERVICE POINT
 
 
<<A>> WIRING HARNESS CONNECTOR DISCONNECTION
noteWhen disconnecting the side-airbag module connector, unlock the connector by sliding the locking button to the direction of the arrow as shown in the figure, and then disconnect the connector.
 
 
 
 
INSTALLATION SERVICE POINT
 
 
>>A<< FRONT SEAT ASSEMBLY INSTALLATION
1. Insert the seat pins to holes of the body securely.
2. Confirm that both the seat slides are locked, and then temporarily tighten the front side bolts so that no load is applied to the seat cushion.
3. Tighten the front side bolts to the specified torque.
Tightening torque: 43 ± 8 N·m (32 ± 5 ft-lb)
4. Move the seat forward.
5. Confirm that both the seat slides are locked, and then temporarily tighten the rear side bolts so that no load is applied to the seat cushion.
6. Tighten the rear side bolts to the specified torque.
Tightening torque: 43 ± 8 N·m (32 ± 5 ft-lb)