[Previous][Next]
REMOVAL AND INSTALLATION
 
 
warningFor removal and installation of the passenger's side air bag module, always observe the service procedures described in GROUP 52B, Driver’s Air Bag Module to Passenger’s (Front) Air Bag Module .
The following bolts and screws are used for installing the instrument panel. Bolts and screws are indicated as marks shown in the illustration in the sections of "Removal and Installation" and "Disassembly and Assembly."
NameSymbolDimensions mm (screw diameter × screw length)ColorShape
Tapping screwa5 X 12-
b5 X 12-
Bolt with washerc6 X 12-
d6 X 12-
 
 
caution
  • Refer to GROUP 52B - SRS Service Precautions and Passenger’s (front) Air Bag Module before removing the passenger’s (front) air bag module.
  • Do not subject the SRS-ECU to any shocks when removing or installing the instrument panel.
Pre-removal and Post-installation Operation
  • Front Pillar Trim Removal and Installation (Refer to )
  • Glove Box Removal and Installation (Refer to )
  • Instrument Panel Driver Side Under Cover, Instrument Panel Cover Lower Removal and Installation (Refer to )
  • Heater Controller Assembly Removal and Installation (Refer to GROUP 55A, Heater Control Unit ) <Except vehicles with automatic A/C>
  • Automatic A/C Controller Assembly Removal and Installation (Refer to GROUP 55B, Heater Control Unit ) <Vehicles with automatic A/C>
  • Floor Console Assembly Removal and Installation (Refer to )
  • Radio and CD Player Assembly Removal and Installation (Refer to GROUP 54A, Radio and CD Player ) <Vehicles with radio and CD player>
  • Smartphone Link Display Audio Removal and Installation (Refer to GROUP 54A, Smartphone Link Display Audio ) <Vehicles with smartphone link display audio>
  • Combination Meter Removal and Installation (Refer to GROUP 54A, Combination Meter )
Removal steps
1.Thread forming bolt
2.Instrument panel harness clamp
<<A>>3.Instrument panel assembly
4.Ventilator air distribution duct
5.Defroster nozzle
6Instrument panel side air outlet
7.Instrument panel
 
 
REMOVAL SERVICE POINT
 
 
<<A>> INSTRUMENT PANEL ASSEMBLY REMOVAL
Remove the steering column shaft assembly mounting bolts to remove the instrument panel (Refer to GROUP 37, Steering Shaft ).