Before servicing, electric motor switch OFF, disconnect 12V battery negative terminal and wait for 3 minutes or more (discharges electricity held in the additional power supply circuit of the air bag diagnosis sensor unit).
Battery posts, terminals and related accessories contain lead and lead compounds. WASH HANDS AFTER HANDLING.
Replace satellite sensor of deployed front side air bag module, deployed front center air bag module and deployed curtain air bag module.
Never damage front door satellite sensor harness, B-pillar satellite sensor harness and C-pillar satellite sensor harness.
To prevent damage to the parts, never impact the satellite sensor.
Always install normally aligning to the cutout hole, because performance of the satellite sensor excessively fluctuates according to the installation position.
Pre-removal Operation
Change the power supply mode of the electric motor switch to OFF.
After installation is completed, perform Diagnostic Trouble Code using M.U.T.-III SE or air bag warning light, if the system is normal and "Stored DTC" of "Diagnostic Trouble Code" is indicated, always perform "Erase DTCs" of "Diagnostic Trouble Code" using M.U.T.-III SE. Refer to Work Flow Work Flow.
After the work is completed, check that no system malfunction is detected by air bag warning light in the user mode.
![[Previous]](../../../buttons/fprev.png)
![[Next]](../../../buttons/fnext.png)
)
)
