Work Procedure
Always perform the distance sensor configuration after replacing the distance sensor.
Always perform the radar alignment after removing and installing or replacing the distance sensor.
caution
The system does not operate normally unless the distance sensor configuration and the radar alignment are performed. Always perform them.
Perform the AEB system action test to check that the AEB system operates normally.
1.
DISTANCE SENSOR CONFIGURATION
Perform the distance sensor configuration with M.U.T.-III SE. Refer to
Work Procedure
.
:
2.
PERFORM RADAR ALIGNMENT
Perform the radar alignment. Refer to
Work Procedure
.
:
3.
AEB SYSTEM ACTION TEST
Perform the following system action test.
LDW: Refer to Work Procedure
Inspection Procedure
.
LDP: Refer to Work Procedure
Inspection Procedure
.
BSW: Refer to
Work Procedure
.
Active Blind Spot Assist [ABSA]: Refer to
Work Procedure
.
TSR: Refer to
Work Procedure
.
RCTA: Refer to
Work Procedure
.
DAA: Refer to
Work Procedure
.
Check that the each system operates normally.
:
INSPECTION END